NTS0104GU12 questions about zswatch HOT 14 CLOSED

Hi @DREAM669

which pull-up resistors do you mean? The IC has internal pull-up resistors attached to its inputs and outputs. Please check the datasheet on page 15 topic 14.2.

from zswatch.

Okay, let me sort out the current issues.
1.After connecting the connector to the display screen, measure the IIC voltage. SDA and SCL changed from normal 3.3V to 2.7V and 2.5V
2. After downloading the program, the Touch function does not work. Is it due to voltage issues that the Touch chip cannot be driven?
Thank you very much for your reply!

from zswatch.

Okay, let me sort out the current issues. 1.After connecting the connector to the display screen, measure the IIC voltage. SDA and SCL changed from normal 3.3V to 2.7V and 2.5V 2. After downloading the program, the Touch function does not work. Is it due to voltage issues that the Touch chip cannot be driven? Thank you very much for your reply!

What PCB version did you order? Because we never had a BOM with this wrong logic shifter. (I think)

from zswatch.

Initial version PCB. The version using TXB0104 frequency conversion chip. But I soldered NTS0104 onto it again, replacing TXB0104. May I ask, after you connect the display screen, is the voltage of IIC still 3.3V? No decline? thank you.

from zswatch.

Initial version PCB. The version using TXB0104 frequency conversion chip. But I soldered NTS0104 onto it again, replacing TXB0104. May I ask, after you connect the display screen, is the voltage of IIC still 3.3V? No decline? thank you.

Please provide the commit you used. So I can look in kicad files

from zswatch.

I am using your first version. You didn't encounter this situation at the time, did you?

from zswatch.

I am using your first version. You didn't encounter this situation at the time, did you?

from zswatch.

@DREAM669 here are the options:
You can compare what's changed between those commits if you want. I don't THINK I changed anything but the logic converter IC, but to be sure you can compare the project at those staged.

Does your PCB have two display connectors?

https://github.com/jakkra/ZSWatch/commits/2d1239c33277a1e8265a1d9a83ca3023761b2155/ZSWatch-kicad-v2

from zswatch.

Okay, I understand what to do now. I will try to compare. There is only one connector on the PCB. Thank you.

from zswatch.

@DREAM669 I made many different version, so I'm not sure which one

Okay, I understand what to do now. I will try to compare. There is only one connector on the PCB. Thank you.

Ok, then you are here. Just see if I changed something else on the PCB, if not you may have a soldering issue.

from zswatch.

May I ask if the voltage converted by NTS0104 after connecting the display screen is 3.3V? Or is there a decrease? Thank you for your reply!

from zswatch.

May I ask if the voltage converted by NTS0104 after connecting the display screen is 3.3V? Or is there a decrease? Thank you for your reply!

Will measure when I have a chance. May be a day or two.

from zswatch.

Thank you very much for your help! Looking forward to your voltage measurement results.

from zswatch.

Finally, it was discovered that the pin pin definition was incorrect. Thank you

from zswatch.