2 Garagedoors about hcpbridge HOT 4 OPEN

Hi Harry,

maybe I can help you. In my Fork I use ArduinoHa from https://github.com/dawidchyrzynski/arduino-home-assistant. It is easier to handle your devices and sensors for homeassistant.

Do you use a separate controller for each garage door?

from hcpbridge.

Hi Handy Harry,

Re controlling 2 doors, you could use Node-Red to connect to 2 controllers then "wire" the logic between them and then interface to home assistant (I have done a simple HTTP request from Node-Red to the existing code to interface with the board which returns the reqiured messages to build the logic)

I like the idea of the PCB --- couple of questions

• what did you use to design the PCB?
• how did you get it made?
• would you share any source files please?

from hcpbridge.

Also - you can run Node-Red from HomeAssistant (I run HA on a Raspberry pi with Node-Red and also the Mosquitto MQTT broker.

from hcpbridge.

Yeah, I have look into it again. So many projects, so little time ;-)
The PCB is just the connections original layout I created in easyEDA and ordered by jlcpcb, but it was with the faulty TX0 and RX0. Also it was to big in the Hormann compartment.

from hcpbridge.