Engine Ignition Sensor Not Working about homeassistant-subaru HOT 3 CLOSED

@tango2590 the state of the ignition (or any other sensor) is a snapshot in time during the last update from the vehicle. With a remote engine start scenario, the state (assuming no manual location requests have occurred) will be what was reported at the last engine shutdown (i.e. off). The confirmation from the MySubaru app is a based on a success message rather than an updated state. The integration supports the same success notification, but you have to enable it in the integration configuration. This does not update the ignition state, since the success notification message carries no vehicle notification information. As of v0.4.0rc4, I've added an additional vehicle fetch request immediately after a successful remote start/stop, which will hopefully update the state.

from homeassistant-subaru.

Closed as unable to fix (due to API limitations)

from homeassistant-subaru.

Good to know the remote start/stop include a poll, my flows re-poll the vehicle every 2 minutes after remote start. I will update accordingly

from homeassistant-subaru.