missing control code for insert line about pigfx HOT 6 CLOSED

On Fri, Sep 4, 2020, 1:50 AM Christian Lehner ***@***.***> wrote: I'll have a look at these missing escape codes. esc [2J currently has to clear the sprites too, as it overwrites the whole screen content with background color. It would be quite painful to redraw every active sprite afterwards. What I could do is a command for only clearing active sprites. Would that be of help? — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#38 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AQIK5ZC7ABKP34QW734GIWDSECE2BANCNFSM4QW7JMUQ> .

There's no stored data removed. Only the defined sprites are removed. You can simply redraw them with the bitmap index you loaded before. ________________________________ Von: lindoran ***@***.***> Gesendet: Freitag, 4. September 2020 14:25 An: fbergama/pigfx ***@***.***> Cc: Christian Lehner ***@***.***>; Comment < ***@***.***> Betreff: Re: [fbergama/pigfx] missing control code for insert line (#38) Clearing the screen of everything is is fine, it is supposed to do that but clearing the stored sprites is excessive because you then have to re load them to memory on the pi ( a large hex bitmap can take 3 minutes or more even with RLE.) Which is why I use smaller tiles loaded as needed and generally I use data that's stored in the host computers memory as loading from the SD card is very time consuming in this way as it greatly contributes to load time. On Fri, Sep 4, 2020, 1:50 AM Christian Lehner ***@***.***> wrote: > I'll have a look at these missing escape codes. > esc [2J currently has to clear the sprites too, as it overwrites the whole > screen content with background color. It would be quite painful to redraw > every active sprite afterwards. What I could do is a command for only > clearing active sprites. Would that be of help? > > — > You are receiving this because you authored the thread. > Reply to this email directly, view it on GitHub > <#38 (comment)>, or > unsubscribe > < https://github.com/notifications/unsubscribe-auth/AQIK5ZC7ABKP34QW734GIWDSECE2BANCNFSM4QW7JMUQ > > . > — You are receiving this because you commented. Reply to this email directly, view it on GitHub< #38 (comment)>, or unsubscribe< https://github.com/notifications/unsubscribe-auth/APMV47HBO2RECV44ORHOHSTSEDMDHANCNFSM4QW7JMUQ >. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#38 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AQIK5ZD2BVJALFRR3UWREEDSEDYXTANCNFSM4QW7JMUQ> .