Simulate Madoka room thermostat with P1P2Serial about p1p2mqtt HOT 4 OPEN

This is not yet possible (or not yet known how to), but I hope to dive into this and get it to work. If not, I have been working on a work-around to achieve the same effect.

from p1p2mqtt.

A fake room temperature can now be generated by the P1P2MQTT bridge for Daikin E-series systems. This may help to avoid an error message on certain systems that the bridge does not generate a temperature, but we do not know which systems require or accept this.

Command F1 will switch this function on, with default reported room temperature of 20.0C. Command F1 205 will change the fake temperature sensor to 20.5C. The permitted room temperature range is 0.0C-25.5C. Command F0 will switch this function off. By default this function is off. It will also switch off after an ATmega restart, the state is not yet stored in EEPROM.

from p1p2mqtt.

Hi I tried this option today with the v0.9.53 two things I mentioned.

• The "F1" is reset after a restart of the Heatpump (as you have written above) Could you store it in the EEPROM?
• at my Daikin Altherma 3 GEO - (EGSAX06DA9W) the Room temperature is always 25.6°C I can't change the value to a different one. this value is shown in MQTT and on the display

from p1p2mqtt.

Can you test P1P2Monitor v0.9.54? It should store the setting in EEPROM and should fix the 25.6C bug.

from p1p2mqtt.