D8 sets boot loader into programming mode about nmea0183-wifi-multiplexer HOT 4 CLOSED

Hi Hinnerk,

many thanks for reporting this issue. The solution is to use D6 insted of D8. I will do the updates as soon as possible.

I did not realise that D8 means GPIO15 on the ESP8266.
And during testing without level shifter it worked perfectly.

Regards,
Andreas

from nmea0183-wifi-multiplexer.

Changes done.

from nmea0183-wifi-multiplexer.

Ah, sure, that is the simple solution, it worked, while testing everything without the level shifter... Just hoped for a better solution than cutting tracks on the PCBs and run a wire... Just had three boards delivered and found the issue putting everything together. :-/

from nmea0183-wifi-multiplexer.

Hi Hinnerk,

Unfortunately, there is no better solution for the old PCBs. But cutting one wire would have been enough. Just cut D8 line and connect to D6. Then change the pin definitions in the code.

And: This is a free of charge DIY solution. This is not a cmmercial product with all testing done and warranty. And my ability to buy and test the full hardware with the PCB is limited. But I'm happy to react on identified issues and do the corrections/improvements (as I did here).

The situation would be better if at least a few people would use the PayPal button for donations for new hard/software.
But so far only one person used this opportunity.

Regards,
Andreas

from nmea0183-wifi-multiplexer.